It can be seen (Figure 6) that the Q e value does not change much in the pH range from 6 to 12. These results suggest that the synthesized adsorbent can be effectively used for adsorption of cesium ions over a wide pH range, but more effectively in neutral and basic solutions. Figure 6 Effect of pH on the adsorption of cesium ions onto the KNiHCF-loaded PP fabric. Initial cesium concentration = 1,000 mg/l. Effect of sodium ion concentration on cesium ion adsorption The adsorption of cesium ions depends on the concentration of competitive ions. In this study we considered the competition of sodium ions with respect to the adsorption of cesium ions. Sodium
ions are abundant in both seawater and freshwater, and they are the main chemical PS-341 clinical trial constituent in a typical evaporator concentrate from nuclear power plants [3]. The effect of competitive sodium ions on the adsorption efficiency of the KNiHCF-loaded PP fabric was studied keeping the concentration of cesium ions constant (36 mg/l or 0.026 mM/l) and varying buy RGFP966 the concentration of sodium ions (0.1 to 1 M/l) under basic condition (pH ~ 9.0). Figure 7 indicates that within the sodium concentration range of 0.1 to 0.68 M/l (where the ratio Na/Cs ≤2,615), the cesium adsorption efficiency has a maximum and decreases with the increase in sodium ion concentration up to the studied concentration
of 1.0 M/l. These results indicate that the adsorption efficiency of cesium ions is affected by the presence of sodium ions in the solution due to the competition of sodium ions for available exchange sites. However, the observed results testify to the high selectivity of the synthesized composite adsorbent to cesium ions, and it can be used efficiently even in the presence of high concentrations of sodium ions. It should be noted that typical divalent cations such as Ca, Mg, Cu, and Pb show no or very little effect Selleck Neratinib on cesium ion adsorption efficiency by HCFs. Figure 7 Effect of sodium ion concentration on the adsorption efficiency of the KNiHCF-loaded
PP fabric. Initial cesium concentration = 36 mg/l; pH ~ 9. Conclusions A novel composite adsorbent based on polypropylene fabric with chemically bound nanoparticles of potassium nickel hexacyanoferrate was successfully prepared by a two-stage experiment: radiation-induced graft polymerization of acrylic acid onto the surface of nonwoven polypropylene fabric followed by the in situ formation of KNiHCF nanoparticles and their stabilization on the fabric surface within the grafted chains. SEM, FT-IR-ATR, and X-ray diffraction techniques confirmed the formation of KNiHCF as crystalline nanoparticles with a face-centered cubic structure. The cesium adsorption on the composite adsorbent based on the KNiHCF-loaded PP fabric was studied as a function of contact time, pH, and the presence of competitive sodium ions.
No related posts.