Thiol-functionalized MGO powder was added to 25 ml of water solution with different concentrations of Hg2+. NaOH was used
to adjust the pH of the solution. While the temperature was kept stable by using a water bath, the samples were placed on a standard rocker and oscillated for given hours. The supernate was collected by magnetic separation for reproducibility test. After washing Capmatinib cost with diluted HCl (0.25 N), the thiol-functionalized MGO was re-immersed in the solution with an initial Hg2+ concentration of 100 mg l-1 and oscillated for 48 h. Characterization The X-ray diffraction (XRD) pattern was taken on a D/MAX-RB diffractometer using Cu Kα radiation. Investigation of the microstructure was performed by transmission electron microscopy (TEM, JEOL JEM-2010 F, JEOL Ltd., Akishima, Tokyo, Japan). Water bath sonication was performed with a
JYD 1800 L sonicator (100 to 2,000 W, ZhiXin Instrument Co., Ltd, Shanghai, China). Hg2+ concentration was determined by using a DMA-80 direct mercury analyzer (Milestone S.r.l., Geneticin mouse Sorisole, Italy). Results and discussion GO was prepared from natural graphite using modified Hummer’s method [16, 17]. Fe3O4 nanoparticles were deposited on graphene oxide by decomposition of Fe(acac)3 in NMP solution (Figure 1, step A) at 190°C [18]. Figure 2a shows the XRD pattern of the product. The peaks at 30.2°, 35.5°, 43.1°, 53.5°, 57.0°, 62.4° in the pattern could be Baf-A1 ascribed to diffraction of (220), (311), (400), (422), (511), and (440) crystal planes of Fe3O4 (magnetite, JCPDS no. 75–0033). Based on the Scherrer analysis
of the pattern, the crystallite size of Fe3O4 was estimated to be 13.0 nm. The appearance of the magnetite phase was consistent with the electron diffraction pattern (inset in Figure 2b). The TEM image (Figure 2b) of the product showed that GO was decorated with magnetite aggregates with a size of several tens of nanometers. In the synthesis process, carbon monoxide was generated at a relatively high temperature and partially reduced Fe3+ to Fe2+. Then, the magnetite selleck inhibitor nanocrystals nucleated and grew at the oxygen-containing defects sites such as carboxyl, hydroxyl, and epoxy groups [14]. Finally, MGO was obtained. Thiol functional groups were grafted on the MGO by the reaction between MEA and carboxyl groups on GO activated by EDC (Figure 1, step B). Energy-dispersive X-ray spectroscopy (EDAX) analysis (Figure 2c) indicated the appearance of the sulfur element, indicating that the thiol groups were successfully grafted on MGO. Thus, the thiol-functionalized MGO was obtained after the reaction. The magnetic properties of the thiol-functionalized MGO were investigated using a superconducting quantum interference device (SQUID) magnetometer. Figure 3 shows the hysteresis loop of the thiol-functionalized MGO hybrids at room temperature (300 K). The saturation magnetization was 22.0 emu g-1, which was much smaller than 92.
No related posts.